All plastic parts (except for the motor base) remove for easy cleanup in the dishwasher. To clean the cutter/strainer, run water over the strainer basket and brush off excess fiber buildup or pulp. The pulp bin container can be emptied by turning the extractor OFF and removing it from the unit. For easy cleanup, place a plastic grocery bag in the pulp bin container to collect the pulp and once juicing is complete, simply discard.
In our tests, this juicer created the least amount of froth of any machine we tested, which means you get fewer bubbles and waste and more juice. Our food-prep time was minimal. This juicer has a 3-inch-wide food chute, so you don't have to spend a lot of time chopping fruits or veggies to fit. However, you need to spend some time cleaning this juicer, since it comes with nine separate parts. Still, this process is made somewhat easier by the included cleaning brush. Plus, some parts are dishwasher-safe. This is a big machine, so you probably want to find a spot on a kitchen counter to store it for daily use. It comes with a tall pitcher, a froth separator and a nonslip base so it stays in place during operation. This is a noisy juicer but no more so than any other – they're all fairly loud.
Whereas the Omega J8004 is a commercial-quality machine, the Omega NC800 is designed for household use. When it came to green juice, the output was almost identical. The carrot juice was a different story, though. The NC800 yielded only 12.3 ounces. John Kohler at DiscountJuicers.com said that this machine put out 15 percent more juice than its predecessor, but we found that it actually put out 25 percent less carrot juice than the J8004. The nice feature of this juicer is that it boasts a larger feed tube than its predecessor, which makes prep a little easier.
To open a can, push front of cutting assembly backwards to lift the blade. Make sure the flip-up magnet is in the up position. Tilt top of can in to position cutting blade inside rim of can. Push down top of cutting assembly to start the cutting action. To remove the can, hold the can and push backwards on front of cutting assembly again. To remove the cutting assembly for washing, twist release button on front of can opener clockwise and lift out cutting assembly. Wash, rinse, and dry thoroughly. If you want to wash the cutting assembly in the dishwasher, remove flip-up magnet first by grasping one side near hinge and pulling out slightly until magnet releases from hinge. To replace cutting assembly, place it in position and firmly press both sides until it snaps into place.
Traditionally, this is the most common type of juicer. These typically utilize a fast-spinning metal blade that spins against a mesh filter, separating juice from flesh via centrifugal force. The juice and pulp are then separated into different containers. The problem with centrifugal juicers is that the fast-spinning metal blade generates heat, which destroys some of the enzymes in the fruits and vegetables you're juicing. The heat also oxidizes those nutrients, rendering less nutritious juice than a cold-press juicer.
The high RPM associated with centrifugal juicers also generates a lot of foam which drives more oxygen bubbles into the juice, resulting in the lower shelf life of the juice. Juice extracted by centrifugal juicers spoil rather quickly due to the oxygen-laden foam and must be consumed immediately. With this, you cannot hope to make a bulk of juice and store for later.
This juicer is worth it's value. That said I note that since it is a sintrifical force juicer it seems to make much more frof then other slow grind type juicers and the remining pulp is still wet, so not all of the juice was removed ( or more could have been removed). I do like the eaz of break-Down and and reassemble and it is easy to clean. It is small enough for the counter or storage area. If you are starting out and looking to explore the world of juicing - start right here. Enjoy!!